What are the reasons for wood working CNC machine carving dislocation?
It is very common for woodworking engraving machines to be dislocated during the engraving process, because there are many problems and many parts involved, so it is a difficult problem to solve. Below we summarize the following aspects for everyone refer to:
1. The cause of the driver: the structure of the driver itself or the electronic components will cause misalignment, which is the most common reason; if the frequency of occurrence is not many, and the speed is lowered, sometimes it can be engraved normally, which means that the driver has not yet It is completely broken. If it is misplaced at the beginning of engraving, it means that the drive is completely broken. This kind of drive can be repaired or worse.
2. The reason for the voltage: the power required for work is large. If the voltage is too low to supply enough power to the driver, the power will not reach it, which will cause misalignment. Generally, the y-axis is the most. This phenomenon may be due to insufficient external voltage. Or someone uses high-power equipment such as electric welding on the same line. The best way to solve this is to install a 50,000-watt regulated power supply, but the error range of this regulated power supply should not exceed 5%, preferably within 3%. .
3. Reasons for the interface board, main board, and adapter board: If the interface board, main board, and adapter board are broken, the machine will not move in a certain direction or three axes during the working process, resulting in engraving misalignment.
4. Spindle motor reason: If it is a stepper motor or a servo motor, the whole machine does not move in a certain direction, and the screw cannot be rotated by hand.
5. The reason of the fuselage itself: there is a problem or looseness of a certain part on the machine tool, and there will be misalignment imagination if there are impurities on the surface. For example, if the coupling is loose or broken, there will be misalignment. Misalignment will also occur during cleaning and refueling.
6. This phenomenon will also occur if the machine tool line of the wood working CNC machine is broken.
