1. Try to ensure that the continuous running time of the advertising engraving machine is within 10 hours every day. The cooling water should be kept clean, and the water pump should be able to work normally. The water shaft motor must not be short of water. Replace the cooling water to avoid excessive water temperature. When the temperature is low in winter, we can replace the water in the water tank with antifreeze.
2. After each use of the advertising engraving machine, you must not forget to clean it. There may be dust on the transmission system. You must pay attention to cleaning it up. The platform fluid should be kept clean at ordinary times, and the vibration system should be lubricated regularly every week. When lubricating and refueling, it should be noted that the xyz optical axis uses engine oil, and the screw part uses high-speed butter. In winter, the weather is cold and the temperature is too low. We can clean the lead screw and polished rod with gasoline first, and then refuel, otherwise it is easy to cause machine misalignment due to excessive resistance.
3. When the advertising engraving machine is doing maintenance and inspection of the electrical parts, remember to cut off the power first, and wait until the monitor does not display and the indicator light of the main circuit power supply has gone out before operating. Regarding how to maintain the advertising engraving machine, the above is some relevant knowledge compiled by Xiaobian for everyone. Any machine should be maintained and maintained while using it, which can not only increase work efficiency, but also prolong the service life of the machine.
The above is the content of the daily maintenance of the advertising engraving machine, I hope it will be helpful to you.
