CNC woodworking engraving machine is an important production tool for wood processing, and production capacity is very important. CNC woodworking engraving machine will present various dislocation problems during the carving process, such as left and right dislocation, up and down dislocation, x-axis dislocation, z-axis dislocation, etc. What is the reason for the woodworking engraving machine to appear dislocation phenomenon?
First, the problem of the CNC woodworking engraving machine itself: a certain part on the machine has a problem or is loose, and there will be misalignment if there are impurities on the surface; if the coupling is loose or broken, it will also be misplaced; guide rails, screw rods Misalignment will also occur if there is no cleaning and refueling for a long time; if the CNC woodworking engraving machine line is broken, it will also appear dislocation. The poor contact of the control lines connecting the various parts of the engraving machine (control line transmission line) will also appear misaligned.
Solution: remove all connections and reinstall.
Second, the problem of the driver of the CNC woodworking engraving machine: the layout of the driver itself or the problem of the original electronic equipment will also cause misalignment. This is the most common reason; This shows that the drive is not completely broken; misalignment at the beginning of engraving means that the drive is completely broken.
Solution: patch the drive or replace the drive.
Third, check whether the path of the engraving software is correct or not; the CNC woodworking engraving machine manufacturer checks the size of the gap of the screw rod of the CNC woodworking engraving machine and whether the fastening screw of the polished rod is loose; checks whether the software parameters are set correctly; checks whether the ground wire is connected;
Fourth, check whether the computer has viruses or is incompatible or disturbed by others, and whether the coupling on the front and upper part of the water-cooled spindle motor is loose or damaged. You can check to tighten it by hand or replace it.
Fifth, check whether the line connecting the beam to the machine control box is in poor contact; the voltage problem: the CNC woodworking engraving machine requires a lot of power during operation, if the voltage is too low, the power supply to the driver is insufficient, and the power cannot reach It will cause misalignment, which is usually caused by y-axis misalignment. This phenomenon may be due to poor external voltage, or someone uses high-power equipment such as electric welding on the same line.
Solution: Install a 5000-watt regulated power supply, but the error range of this regulated power supply should not exceed 5%, preferably within 3%. Problems with the interface board, main board, and adapter board: If the interface board, main board, and adapter board are broken, the woodworking engraving machine will not move in a certain direction or three axes during the operation process, resulting in carving misalignment. Spindle motor problem: If there is a problem with the stepping motor or servo motor, the whole machine will not move in a certain direction, and the screw cannot be rotated by hand.
