How to quickly and correctly install the cutter of the woodworking engraving machine?
The woodworking engraving machine tool is installed correctly, the engraved pattern can be more accurate, and the tool is not easy to break during use, how to quickly and correctly install the woodworking engraving machine tool? APEXTECH woodworking engraving machine lists the following steps, hoping to be helpful to everyone.
1. There are many gaps on the chuck. Before clamping the tool each time, clean the chuck with gasoline or WD40 cleaning agent, and check and remove the residue in the gap of the chuck;
2. The fit between the collet and the shaft depends on the contact with the taper hole at the shaft end. If the contact is not good, the tool is not easy to install. It is necessary to ensure good contact with the taper surface. The cone surface of the shaft must be scrubbed clean with gasoline or WD40 cleaning agent before the knife is installed;
3. Put the collet into the pressure cap, turn the clamp spring slightly, wait until the eccentric part of the pressure cap is recessed into the collet groove, push the collet evenly in the direction of the arrow, and then put it into the pressure cap;
4. The collet and the pressure cap are installed together on the machine tool spindle. After cleaning the cylindrical shank of the tool, put it into the holding hole. After confirming that the collet and the tool are aligned, screw the pressure cap in place by hand. Then use a wrench to tighten the pressure cap evenly until the tool is clamped firmly before use;
5. When loosening the tool, use a wrench to twist the pressure cap in the opposite direction. If you need to change the chuck, loosen the pressure cap to take out the chuck and the tool, remove the tool, push the chuck hard in the direction of the arrow to push it out, and then as needed Just replace it with a collet with another hole diameter.
