The Lack of Maintenance of The Atc Cnc Woodworking Router Machine Will Bring Us Big Trouble?
A small problem with the cabinet door engraving machine will bring us big troubles: Whenever we use machinery, we need to maintain the equipment. Of course, woodworking engraving machines also require regular maintenance and repairs by users. If we do not do a good job in the maintenance of the cabinet door engraving machine, or even neglect it. Then some minor problems of the cabinet door engraving machine may bring us big trouble.
1).The main shaft of many woodworking engraving machines is water-cooled. If the temperature is too low, it will easily freeze the main shaft and the circulating water pipe, and easily damage the main shaft.
2).At present, frequency converters are mostly used to drive asynchronous AC motors. Low-power non-inductive vector frequency converters are small in size and cost-effective, and are mostly used in engraving machine systems with spindle power below 3.7KW.
3).The copper loss and iron loss of the motor of the engraving machine will be manifested in the form of heat, which will affect the efficiency of the motor. Stepper motors generally pursue positioning accuracy and torque output.
We know that 3 skilled workers are debugging a two-to-eight woodworking engraving machine. In less than ten minutes, 8 roses were carved on 8 flower boards. It can be imagined that under such an efficient operation of our cabinet door engraving machine, not only our main shaft but also the motor will have great wear and offset. Once the engraving knife of the cabinet door engraving machine deviates, not to mention high-precision operations such as roses, even ordinary engraving will have large and serious deviations. Therefore, in our actual production process, you can touch it with your hands for more than 1-2 seconds, and it does not exceed 60 degrees; you can only touch it with your hands, and it is about 70-80 degrees; a few drops of water quickly vaporize, and it is above 90 degrees. It is to reduce copper loss and iron loss. In this case, we can choose antifreeze instead of water. If possible, it is best to choose air cooling instead of water cooling for the spindle when purchasing an engraving machine.
Of course, the guide rails (square rails or compasses) and racks of the cabinet door engraving machine should be cleaned and oiled frequently, and the wires should be checked for aging or breakage to avoid leakage.
