The use of woodworking engraving machines is becoming more and more extensive. While using them, maintenance is also very important. After the work of the woodworking engraving machine is completed, the table should be cleaned in time, and the material scraps next to the guide rail should also be cleaned in time to prevent machine jamming; the screw is also very important in the equipment, which determines the accuracy of the machine, so clean the wire regularly The rod is also very important, which can effectively prevent foreign matter from attaching to the lead screw; dust is the biggest factor affecting the circuit board, so the industrial control box must be cleaned regularly.
Oiling plays an important role in the maintenance process of woodworking engraving machine. After cleaning the guide rail and lead screw, apply engine oil; the refueling cycle is usually once every two weeks; after refueling, remember to walk back and forth slowly to ensure the degree of lubrication; even if the woodworking engraving machine is not used for a long time, it should be refueled regularly Walk.
We all know that the mechanical equipment of the production line needs regular inspection and maintenance to ensure its excellent performance. During the inspection process, I often ignore the inspection of newly replaced parts.
Before replacing parts, some maintenance personnel do not perform technical inspection on new parts, and directly install them on construction machinery after they are brought, which is unscientific. At present, the quality of spare parts sold in the market is uneven, and some fake and shoddy parts are misunderstood; there are also some parts whose performance has changed due to the long storage time. If they are not tested, they often cause failures after assembly.
After dismantling the side cover of the new oil cooler, it was found that the oil sealing ring at the side cover was not compacted, causing the oil and water to mix, because the quality of the oil cooler was not up to standard. 1 ZL50 loader, the oil pressure of the diesel engine is too low, the analysis is that the oil filter is clogged, a new oil filter is replaced, the oil pressure of the test machine is still low. Therefore, before replacing new accessories, necessary inspection and testing must be carried out. The inspection includes appearance and performance tests to ensure that the new accessories are fault-free and prevent unnecessary troubles caused by them.
Although regular inspection and replacement of damaged parts of the woodworking engraving machine can effectively reduce the probability of failure, we also need to check the quality and matching of the newly replaced parts, so that the woodworking engraving machine can operate normally.
