How to set the cutter so as not to hurt the table of the engraving machine?
When the woodworking engraving machine is working, the tool often touches the table. How to set it to keep the tool from hurting the table?
The first is the parameter setting problem. When the woodworking engraving machine is positioned on the Z axis, it does not let the knife touch the material surface, but removes the material so that the knife touches the table directly. The axis returns to zero first, and then increases the corresponding height according to the cutting depth set in Wentaili, and then returns the Z axis to zero, which is the origin of the Z axis. According to the setting depth of Wen Taili, the lowest point of the engraving machine is the place where we reset to zero for the first time, which happens to be on the top of the table, so as to ensure that the material is completely engraved without hurting the table of the engraving machine.
Secondly, it is better to add a protective plate on the table of the engraving machine. For example, a woodworking engraving machine with vacuum adsorption table can put a thin Ozon board on the table. The problem of tool damage to the table caused by inaccurate origin setting is solved.
Even if the above-mentioned treatment is done on the countertop of the woodworking engraving machine, accidental scratches will inevitably appear in long-term use. At this time, it is necessary to re-mill the platform. Just reapply one more layer. In addition, it should be noted that when the machine leaves the factory, in order to prevent damage to the countertop during logistics and transportation, it is generally necessary for after-sales personnel to re-mill the platform when they come to install and debug.
