There are two types of broken knives for woodworking engraving machines, one: long-time engraving of high-hardness materials, the wear and tear of the knives and broken blades are inevitable. : The knife is broken, how to replace the new knife to ensure the same height of the two knives, how to continue engraving, these are very realistic problems.
These two common phenomena can be classified as one problem. It can be understood that the situation of severe tool wear is equivalent to the state of broken blade. We can do it the same way. When we find that the tool breaks suddenly during the operation of the woodworking engraving machine, please pause or stop the operation in time. Then write down the current block number, which will be used later. Replace the tool with a new tool after the spindle stops completely, because we change the tool manually, which will inevitably lead to a change in the height of the Z direction. We only need to use the tool setting block to re-determine the origin of the Z direction. There is no change in the X and Y directions, so we don't care about it. After confirming, we find the "Advanced Start" function under the operation menu. The dialog box requires us to input the start line segment number. This segment number is the number we wrote down when we first stopped the machine. It is smaller than the number noted down, and the specific number depends on the time when we found the broken knife. If it is found late, subtract some more numbers. The end segment number defaults to the end of the file. In this way, the woodworking engraving machine can automatically continue carving the unfinished part.
