If you want to engrave patterns with higher precision, you must first install the cutter correctly, so that the cutter can be stronger and not easy to break during use. Then how should we install the engraving machine tool quickly and correctly?
Tool Installation:
1. There are many gaps on the chuck. Before each tool is clamped, the chuck needs to be cleaned with gasoline or WD40 cleaning agent, and the residue in the gap of the chuck needs to be checked and removed.
2. The fit between the collet and the shaft is in contact with the taper hole of the shaft end. If the contact is not good, the tool is not easy to be installed. It is necessary to ensure good contact with the taper surface. The cone surface of the shaft must be scrubbed clean with gasoline or WD40 cleaning agent before using the knife.
3. Put the collet into the pressure cap, turn the clamp spring slightly, until the eccentric part of the pressure cap is recessed into the collet groove, push the collet evenly and forcefully in the direction of the arrow, and then it can be loaded into the pressure cap.
4. The collet and the pressure cap are installed on the machine tool spindle. After cleaning the cylindrical shank of the tool, put it into the holding hole. After confirming that the collet and the tool are aligned, screw the pressure cap in place by hand. Then use a wrench to tighten the pressure cap evenly and forcefully until the tool is clamped firmly before use.
5. When loosening the tool, use a wrench to twist the pressure cap in the opposite direction. If you need to change the chuck, loosen the pressure cap to take out the chuck and the tool, remove the tool, push the chuck hard in the direction of the arrow to push it out, and then replace it as needed. Chucks with other hole diameters can be used.
