In the process of using the woodworking engraving machine, we often need to optimize the engraving path, so that we can gradually achieve a better engraving effect. The following is a simple sharing of the engraving settings.
In the engraving software, users can edit and modify the generated two-dimensional path. When editing, we must first select the path graphics we need to edit, and then click "Sculpting Path Edit" under "Path Calculation", and the tool bar for carving path editing will appear, select the path to be edited, (at this time all node editing functions are all can be used), just edit and modify.
The first item in the tool bar is to define the starting point, and the starting point of the engraving can be specified arbitrarily in the engraving path; the second item is reverse order, that is, change the selected path to the opposite direction; the third item is disconnect, use this function The position of connecting ribs can be added arbitrarily; the fourth item is sorting, which can sort the selected paths; the last item is saving, but we must not forget to save it after we modify it. For the insurance period, the program is loaded to woodworking engraving After the computer is installed, it is necessary to simulate and preview it first to avoid errors.
How to set the engraving starting position of the engraving machine, the starting position is mostly set in the lower left corner or the center, manually move the knife to the required starting point to set the program path of the CNC engraving machine.
First, set the starting point. You can define any point in the engraving path of the CNC engraving machine as the starting point of the engraving path to change the position of the tool drop point during processing. We can adjust the starting position according to the requirements of the processing technology. The second is to set the path reverse, and change the selected engraving path of the CNC engraving machine to the opposite direction, so that the processing direction matches the texture of the processing material. Make the processing effect more perfect. Design arc fitting again, for toolpath and machining calculations, the results obtained using arc curves will be better than short polylines. It can greatly reduce the tool path, save processing time, and make the processed curve smoother.
The last is to set the connecting ribs: the setting of connecting ribs is to avoid damage to the processed parts or processing errors caused by the movement of the processed object before the end of the processing when cutting. It is required that the processed object is not completely disconnected. Separate it by hand. We can set the material with ribs at positions where there is no processing requirement.
